Parameter attribute
①Maximum section size of processing part: φ150mm
②Maximum length of processing piece: 300mm
③CNC system: Siemens
④Diameter of steel wire busbar: ≥0.12mm
⑤Maximum wire running speed: ≤35m/s
⑥The maximum storage capacity of take-up and pay-off reels (mortar cutting): 300km
⑦The maximum storage capacity of take-up and pay-off reels (diamond wire cutting): 50km
⑧Wire operation mode: Bidirectional/unidirectional
⑨Quantity of main cutting rolls: 2
⑩Diameter of idle wheel: φ160mm
⑪Feed slide stroke: 250mm
⑫Cutting feed speed: 0~60mm/min
⑬Fixture swing angle: 0±12°
⑭Maximum capacity of diamond wire cutting fluid tank: 360L
Maximum capacity of mortar cutting fluid:150L
⑮Maximum flow of cutting fluid pump: 200L/min
⑯Feed mode: Front end feed
⑰Warping control: ≤30μm
⑱TTV control: ≤15μm
⑲Power cable: 3×95+50mm
⑳Rated total power of machine tool: 140kw
Dimension of machine tool (without water tank): 4050×1750×3100mm
Equipment weight: 13t
Advantages
①The base of the machine tool, the support of the spindle box, the vertical feed column, and the feed slide are all cast in one structure, providing stable structure for high wire speed;
②The spindle is designed with angular contact bearing and grease lubrication, which is suitable for high precision and high wire speed processing;
③The fixed support spindle motor is hollow shaft with internal cooling to ensure the stable temperature for long-term operation and high accuracy;
④Low inertia roller, designed for easy replacement of the assembly structure;
⑤The fixture is swingable so that the workpiece is cut in swinging manner to ensure the cutting force is uniform;
⑥The crystal holder is designed with mechanical rectangular spring, with trapezoidal groove to ensure the accuracy of the processing crystal direction;
⑦Siemens motion control system and original motor with minimal equipment disconnection rate;
⑧The vertical feeding is designed with U-shaped casting column, 2 guide rails and integrated casting sliding table, which is stable and greatly reduces the possibility of warpage and TTV of slice;
⑨It's designed with the patented wire-break alarm device of the firing mechanism with thin wire and eccentric block to makes sure fast emergency shutdown;
⑩Spindle cooling is designed with separate water tank for water supply, which controls large flow and long flow of water, and is capable of removing the condensation inside the axle box;
⑪The take-up and pay-off systems are respectively located on both sides of the machine tool and installed on the integrated casting base to reduce vibration;
⑫Precise tension control, with near 90° cable angle, which greatly reduces the wear of steel wires;
⑬High precision tension sensor with patented software control system to ensure stable control of thinning process;
⑭Automatic management with the functions of one-key lifting, one-key tool setting and automatic liquid replenishment;
⑮Control quality through silicon wafer surface quality TTV, line marks, edge chipping, overcutting and wire breakage.
