Parameter attribute
①Processing number: 1 pc/knife
②Processing diameter: ≤ø 550mm
③Processing length: ≤750mm
④Wire speed: ≤30m/s
⑤Wire diameter/specification: 0.25~0.42mm/442D, BS60
⑥Average cutting speed: 5~15mm/min
⑦Working stroke range of slide table 100mm-1000mm
⑧Processing margin range: 110~230mm (by replacing or adjusting the distance between the cutting roller machine and the wire wheel)
⑨Wire stored length: ≤20Km
⑩Cutting head no-load moving speed: 0-1500mm/min; ≥40mm/min
⑪Wire mesh tension range: 0-120N
⑫Noise: <80dB
⑬Machine tool power: 59.5Kw
⑭Compressed air pressure: 0.4mpa-0.6mpa
⑮Air flow: ≥40m³/h
⑯Air inlet size: φ16mm
⑰Weight of machine tool: 12T
⑱Dimension of machine tool: 3800*2100*3855mm
⑲Quantity of cutting rollers: 3 sets
Advantages
①Rotary table: The rotary table is provided with 2 crystal support devices in the way that the processing station is separated from the loading and unloading station.
②Cutting area: Vertical cutting, with 2 main motors on the cutting head, each controlling a set of cutting rollers
③The cutting head is installed on the column slide table, and the column slide table is driven by servo for up and down movement.
④The guide wheel bracket is firm and reliable. The guide wheel bearing is air-sealed and lubricated with high grade grease.
⑤The center of the crystal support device is provided with floating support structure to adapt to the inclination of the end face of the positioning surface. After the floating support is in place, it is locked to ensure that the center of the silicon rod is placed vertically.
⑥The linear module is installed in wire regulating wallboard and is protected with protective cover. When maintaining, just remove the protective cover.
⑦The take-up and pay-off reels are provided with disc springs on the extension heads of the two shafts of the reel. The conical positioning sleeve is used to ensure concentricity with the inner shaft when the reel is loaded, and the runout of the far end of the reel is within 0.06mm.
⑧The screw tightening torque of the take-up and pay-off reels is 180 Nm.
⑨Electrical control system: INOVANCE CNC system, Taiwan motion controller, according to customer needs
